Picture Frame Jig for Table Saw
Step 4 Use the wood scraps to make the Backstops to the fences. Nike shoes outlet Make one corner of each board a perfect 90 degree corner. I did this using the TechShop, SawStop table saw and miter gauge.
The “stair steps” I ended up with were based on the final size of each piece of scrap and the intended use of the bottom step as a thumb rest when pushing the jig to make the frame miter cuts. The right side of the jig was left with space to install and support the aluminum Authentic nfl jerseys add on fence for making longer frame sides. Photo 7
After making the Backstop pieces glue, pneumatic gun nail (or, as I have done, use reclaimed drywall screws salvaged from remodel work) to fasten the backstops to the marked lines on the board. Use care to not place Nfl jerseys wholesale the nails or screws in the path of the blade! This is to prevent damage to the blade if you over cut. Also, as a safety feature, the height of the backstop is calculated to hit the top of the riving knife Cheap authentic jerseys above the saw blade, thus stopping the jig from being pushed too far. Photos 8,9.
